on 04-19-2016 4:01 PM
Hi all ,
I have added a column in IBASE RESULT table by using configuration , in our developpement system , i can see it in the webui screen :
But when i transpoted this configuration with tcode SCC1 to our test system , the column appears in the configuration , but when launching the webui page , the column dont appear i cheked if the configuration id is the same , it's ok .
Is there anyone how have an idea about what could be tthe problem ?
Thank you in advance
Hasnaa .
Hello Hasnaa,
It is happening because user/you have personalized the table view.
Reset your personalization and then you will the new column.
I hope this helps.
Thanks,
Kapil
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello,
No need to redo development.
Please refer below link
Reset personalization after config changes - CRM - SCN Wiki
Globally reset user personalization | SCN
Thanks,
Kapil
Hello Kapil Than you again for you response i'm so thankful
So to summarize, i checked in table BSPC_DL_PERSSTOR :
In developpement client i have those entries :
In test client i have those entries :
So if i inderstood i have to run report BSP_DLC_DELETE_PERSONALIZATION by my user in test client in order to delete which one ? because i'm afraid to delete a personalisation by mistake
Hasnaa .
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello Hasnaa,
Go to SE38, run the report BSP_DLC_DELETE_PERSONALIZATION for your username in the client which you are facing the issue.
Thanks,
Pratheek
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Hasnaa,
SCC1 is for client copy, you can not transport your changes from dev to test system using scc1. Did you want to say that you moved changes to your test client?
Can you also please post a screenshot of F2 popup window of your test system or test client?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Exactly we have 2 mndt (clients), one for developpement only with a few data and another for testing our developpements and customising , i used SCC1 just to copy what i did (configuration of view) to test client in order to see the result .
In can see the result of my configuration ( the new column added in the table) in developpement client but not in test client even if i copied my changes
PS : i can see my configuration on transaction bsp_wd_cmpweb in test client , but wech i launch the webui screen , the colulmn dont appears , i understood from the answer of Kapil that maybe have te reset my configuration in order to see the change in the webui screen .
Hasnaa .
User | Count |
---|---|
5 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.