Why Exception Operation Mode (RZ04) timetable does not display which mode is then currently active ?

[Former Member]

Once when we create an exception operation mode and when it is active, the timetable does not display which mode is then currently active.(even though it displays before the mode being active).So my point of concern is:

1. Is it a normal behavior ?

2.If so, how do we check the same after a particular number of days ( say a date so that the system log also gets cleared by then ).

Kindly help me out with this.

Thanks in advance

Edu Krishnan

[Former Member]

Hello Edu,

This is not normal as per screenshot, if you set the exception mode for 19.03.2016.

Hope you saved it after configuring.

Thanks.

Best Regards,

Anita

[Former Member]

Hi Anita,

Thank you for your reply.

YES. I had saved it and the the exception operation mode successfully took place during the mentioned time period ( visible from SM50 ). But then, it did not display the name of the then currently active mode in the table.

Regards,

Edu

[Former Member]

Hi,

Please check below link:

Defining Exception Operation - Configuration - SAP Library

Regards,

Himanshu

[Former Member]

Hi Himanshu,

Thank you for your response.

I had enabled it exactly the way the link you forwarded me.

It successfully executes the exception given( evident for SM50 ), but not visible on the table which mode is active during the mentioned time-span. (as shown in the attached screenshot !

Regards,

Edu