Skip to Content
avatar image
Former Member

Production Order Change - New Batch Determination

Dear All,

I have been facing doubts regarding production order change and new batch determination.

Initial production order is created(CO01) and released having all qty of components automatically assigned to batches based on search and sort procedures(SPRO > LOGISTICS GENERAL > BATCH MANAGEMENT > ...).

Due to some circumstances, production planner has to change original qty of production order(CO02). Hence original qty of components is increased/decreased and presented on additional line above but w/o batch number assigned. Is it a commom behavior? Do I need to assign a new batch manually?

I'd appreciate any advise.


Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • Apr 05, 2016 at 05:27 AM


    If the user change the quantity of component in production order in that case he has to perform the manual batch determination in production order. Or you can do the further batch determination during the good movements. If order is not release then you can release the order it will do the batch determination again.

    Best Regards,


    Message.png (828 B)
    Add comment
    10|10000 characters needed characters exceeded

  • Apr 05, 2016 at 01:45 AM

    Hi Robson,

    You can setup a system to get the batch determination done automatically. This means that if you increased the original quantity the batch determination will be executed again..

    Check if you have batch entry = 3 in the components of your production order.

    Kind Regards,


    Add comment
    10|10000 characters needed characters exceeded

  • Apr 05, 2016 at 09:04 AM

    Hello Robson,

    The Batch determination will depends on the Batch entry which will define in the material master MRP2 View

    if the production order quantity has been increased / Decreased in that situation you have to assign the batch number through the batch determination as suggested by Brahmankar

    So please select that line item and make the batch search procedure

    against that quantity you can be able to select the batch number as per the FIFO process



    Add comment
    10|10000 characters needed characters exceeded