SLED different in LQUA table and batch record

[Former Member]

Hi All,

I have a issue where SLED is different between the WM , i.e in table LQUA and batch record. The flow of sequence is ,a new batch was created with movement type 309, in which a new SLED was calculated based on the Manufacturing date/GR date and the shelf life days in material master. so far so good . SLED in both batch record and LQUA was in sync.

However subsequenty it was decided by business to change the expiry date to past date i.e to make the batch expired. This change reflected in the batch record (MSC3N) However was not transferred to WM. That means in LS02/LS24 /LQUA table ,I still see the old SLED date.

I need to understand the root cause of this so as to prevent this from happening in future.I wanted to see if any of you have faced a similar issue.

All the config is in place and this issue is not observed all the time and I am not able to recreate this issue in Dev/Quality.

Any inputs would be helpful.

Regards,

Shankar

[michael_kozlowski]

check whether SAP note 1573002 is applicable for your system 1573002 - SLED / Date of Manufacture is not updated correctly or it is not set in Warehouse System.

[Former Member]

Hi Michael,

I did check the points in the note 1573002. Out of the 4 points in the note, 3 are not applicable in my case. One point however is what I expect should be normal behavior, however is exactly the opposite in my case.

I am quoting the point from the note below:

"If the SLED is managed in the batch master record and is also transferred to the quant. Changes to the date in the batch master record cause changes in the quant. This avoids a situation where there are several “quants” of a batch with different SLEDs."

So when the changes are done in the batch record, I expect according to the above point to reflect in the quant as well. It does happen in all the cases I have been trying to recreate, even the ones with expiry dates. In all the cases,change in the quant SLED is reflected as soon as it is done in the batch record.

I checked if there were other manually created TO for this batch to see if they have had any impact and there are none. Let me know if there are cases where the Quant is not getting updated for the SLED even if the batch record is getting updated.

Warm Regards,

Shankar

[JL23]

Moderator message: discussion locked because of cross posting:

Please read the forum rules

it is addressed in point 9, but point 8 is also important for you

[former_member1025942]

Hello Shankar,

Have you found any answer to your question? I also have same query but not able to find the exact answer.