avatar image
Former Member

estimate meter reads in billing

hi guys

I want to activate the estimation of mr results in billing but system says "

No objects correspond to the selection criteria"

Is that so we can only use DPC portions for this or else we can even estimate the reads of normal portions also.

In my DPC the status is "READ"

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Mar 22, 2016 at 01:06 PM

    Hi Pankaj,

    Please check below fields are maintained correctly

    1. Periodic consumption @ register level is present

    2. What is the "Base period category" value at installation screen (previous period or periods from Prev year)

    3. What is the min Portion value maintained at Register rate attached to the register (using Rate type & rate cat)

    Regards

    Manoj

    Add comment
    10|10000 characters needed characters exceeded

  • Mar 22, 2016 at 01:23 PM

    Hi Pankaj,

    From which process you are getting this error message? Have you checked whether you have any open Billing Order ? Check in table ETRG or from txn ES32.

    Is that from Billing run or from EL60/EL61/EL62?

    If its from EL60 then you should have open Meter Reading/Billing Order, the Schedule Billing Date and Billing Procedure should match your selection criteria.

    Also please provide message ID and number so that it will be easier to point out the issue (Message No. E9035?)

    Thanks,

    Srini

    Add comment
    10|10000 characters needed characters exceeded

Skip to Content