on 02-26-2006 6:53 AM
Guys,
I have a ALV report program working in 3 modes - create,modify and display. It working fine. And there are 3 tcodes to access each of these modes and they can be toggled between each other.Now for eg. i use zdisplay tcode for display mode, i enter the selection screen and then the report in display mode.When i press back, i should go to the selection screen again. Instead it exits out. What should i write under the PAI event for BACk -
Leave to screen 1000 ? . or Set screen 1000. Leave to screen ?
Thanks,
SHK
leave to screen 1000
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
set screen 0 .
leave screen.
will take you back to the selection screen.
Regards
Raja
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.