on 02-26-2016 5:34 AM
HI All,
I have connected an on-premise system to HCI Odata provisioning service. i have defined it as an a destination in odata provisioning config. and is is saying connection is successful using hana cloud connector. However when i try and register a service on HCP and try to search for services, I get this error :
The config done is :
Troubleshooting message :
Kindly help! Thanks
Hello Gulshan,
Did you find out any solution on this issue, I am facing the same issue and error are also same.
Regards,
Yogesh Pande
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Yogesh Pande.
Could you please share the screen shot for the destination that you have created?
Also, go to the Troubleshooting tab and look for the trace for this exception.
If possible can you provide the trace also.
Thanks & Regards,
Mohan
Hi Yogesh Pande.,
Have you tried using ES4?Its a demo system for trial.. You can test this . In such case, Proxy Type should be "Internet".
As you are using a on premise System, You should use the Proxy Type as "On Premise" and you should have a configuration in the SAP Cloud Connector. Please delete all the additional properties that you have created while creating the destination.
Thanks & Regards,
Mohan
Message was edited by: Mohan Kumar Agarwal
Hell Mohan,
Created the destination with ES4 system without adding any additional properties. Tested it successfully and able to see the ES4 system in Drop down box in Register Services >> Select Destination, however while registering the Services getting same error message as below.
Thanks for your support,
Yogesh Pande
Hi Jitendra,
Thanks for your reply on this, there is no option available to Change HTTP to HTTPS in "TYPE" option on destination screen however I tried using https:// in URL and it didn't work.
Regards,
Yogesh Pande
Hi Yogesh,
The pre-requisite to connect to the On-Premise systems through OData provisioning administration, is to register your systems with the Cloud Connector.
Are your Cloud Connector configurations in place? Please check the OData provisioning documentation for the same. This is mentioned in the "Administration" section. (For some reason, I am unable to copy-paste the documentation link itself).
Hope this helps.
Best Regards,
Kranti
Hi Yogesh and Gulshan
Checking connectiontion from cloud connector to the backend system might be working fine. But have you also done "Check Connection" on the destination configured in HCP? Ensure that the hostname specified in the destination URL in the configured destination is same as the "virtual host" specified in the cloud connector. Also, the Proxy type for the destination must be "On Premise".
Have you taken care of these things?
Thanks,
Kranti
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
HI Jitendra,
Thanks for your answer. I have tried the above mentioned configs and also deleted WebIDE related settings but still no luck. However with the same settings i was able to connect to SAP DEMO ES4 system and fetch services to register.
PFB the error i am fetting in troubleshooting:
Perhaps it can be a proxy setting error i might not be aware of ?
Regards,
Gulshan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
82 | |
10 | |
10 | |
9 | |
6 | |
6 | |
5 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.