cancel
Showing results for 
Search instead for 
Did you mean: 

Resource Hierarchy (sapapo/relhshow)

Former Member
0 Kudos

Gurus:

I'm trying to setup a hierarchy on my resources in /sapapo/relhshow.  I'm looking to have 4 levels (I have setup the config to allow 10 levels for future expansion).  My first level is plant level.  My 2nd level is Group1.  My 3rd level is SubGroup1.  My 4th level is at the actual real Resource.

When I add orders in APO SNP and then go to look at the capacity on the Resources, I get a capacity requirement on my 4th Level (actual Resource) and on the 3rd Level (SubGroup1), but I do not get capacity requirements on my 2nd or 1st Levels up.

I attached a screenprint.  Does anyone have any ideas?  I asked 2 external consultants and they think my setup is correct, so they cannot explain why I wouldn't see capacity requirements on Level 1 and 2 (the 2 highest grouped up levels).

Best Regards,

Andrea

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi Andrea,

Have you defined in customizing the hierarchy has four levels, as in standard it only one level.

Anil

Former Member
0 Kudos

Hi Anil:

Yes, I have actually created 10 Levels.  The lowest 2 levels are working, but no higher levels are showing capacity requirements.

Andrea

Answers (1)

Answers (1)

Former Member
0 Kudos

Hi Andrea,

See if the note 1568018 helps.

Thanks, Nikhil

Former Member
0 Kudos

I put a ticket in with SAP and they told me standard functionality will only support two levels.  I am a bit disappointed as it lets you build as many levels as you setup in config, but will only display the aggregated capacity requirement up to the 2nd level.  I haven't been able to get an explanation from SAP as to why you are allowed to configure other levels.  I didn't want planning to run on those other levels, I just wanted to use the higher up levels to display a total of the capacity requirements from the real work centers at the lower levels.

Andrea