01-08-2016 4:41 AM
Hi ,
Need your help
Actually need to put check against the field “prod. stor location” of MRP-2 view of material master, so that it should allow only a specific value for some required part numbers. System will check the value once input entered in the field while creation of material master / change of material master.
Also check the attached screen shot..
Kindly suggest is there any User/Customer exit available for this ?
Or any other better alternate solution
01-08-2016 6:55 AM
Hello Srini,
Try for BADI: BADI_MAT_F_SPEC_SEL or SMOD enhancement :MGA00001.
Regards,
Thanga
01-08-2016 6:55 AM
Hello Srini,
Try for BADI: BADI_MAT_F_SPEC_SEL or SMOD enhancement :MGA00001.
Regards,
Thanga
01-13-2016 4:03 AM
Hello Prakash,
I have tried with SMOD enhancement: MGA00001.
And the issue has been resolved.
Thanks for your suggestions.
Srinivasa T
01-18-2016 9:41 AM
01-18-2016 10:48 AM
Hello Prakash,
I have not tried the BADI which you have mentioned, just because of SMOD enhancement: MGA00001 fulfilled by requirement.
If i face any issue with MGA00001, I definitely go for that BADI.
Thanks for the Support,
Srinivasa Rao T
01-18-2016 10:58 AM
01-13-2016 4:12 AM
Dear,
The "Prod. stor. location" is meant for the assignment of storage location for those materials which are produced by in-house and also for back lush purpose by your production criteria.
This mainly for production related materials only.
Hope i can under stand you are mapping this for all other stores and spares purpose.Kindly check before mapping this for other than production materials with respect to MATERIAL TYPE.
Regards,
Pardhu
01-18-2016 10:37 AM
Hello Partha,
You have guessed right.
This is for production related materials only. I have checked the same with functional team also.
Thanks for you support.
Srinivasa Rao T