Skip to Content
avatar image
Former Member

Payload is missing in XI adaptor

HI

My scenario is file->XI->Proxy.

Message is showing sucessful in SXMB_MONI,but the output message in payload of XI adaptor is not comming.Under the SOAP Ody only maifest exists,ut no payload can be seen.Also in proxy input structure data is not comming(initial).What can be done??

Thanks

Debraj

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Feb 17, 2006 at 04:28 AM

    Hi debraj,

    Is your XI patched upto SP15?

    if so then, the payload doesnt appear in the SXMB_MONI transaction code. There was no clue to this behaviour. There are also some threads that discussed this.

    Go thro these threads,

    SXMB_MONI does not show payload after upgrade to SP15

    Response payload in SXMB_MONI is missing

    regards,

    P.Venkat

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 17, 2006 at 12:45 PM

    Hi Debraj,

    Have you checked if the queues in Application System are registered ?

    You can go to SXMB_MONI transaction in the Application System(on WAS 620 ) and check if your message is stuck over there.

    Hope this helps.

    Regards,

    Sulakshana

    Add comment
    10|10000 characters needed characters exceeded

  • Feb 17, 2006 at 12:55 PM

    Hi Debraj,

    your trace is too low.

    Transation SXMB_ADM / Configure Integration Engine / Specific Configuration

    Category RUNTIME / Parameter TRACE_LEVEL should be 3 (full trace)

    Parameter LOGGING should be 1 (trace switched on)

    Regards,

    Udo

    Add comment
    10|10000 characters needed characters exceeded