Issue in CUAN_SETUP_ERPCONTENT

[kajajamal]

Hi

While executing the task list CUAN_SETUP_ERPCONTENT, it gets failed in the step 'Setup of SAP ERP Database Trigger'

In task log,

a warning message as 'Parameter P_UT not found; value '' remains unchanged'

an error message as'Monitor your replication for ERP; resume task when replication is finished'.

Can anyone suggest a solution for this.

Thanks,

Jamal

[Former Member]

Hi Jamal,

have ou found a solution here. We are having the same message right not.

BR

Yoro

[kajajamal]

Hi Yoro,

There was some installation problem since our deployment scenario was Add- on installation along with SAP CRM which has been removed from release 1511.

If it is not the same scenario in your case, it's due to some installation problem, please raise OSS ticket.

Regards,

Jamal

[axel_semling]

Hello Jamal,

you can ignore the warning about parameter P_UT.

The issue ist that the replication from SLT system to Hybris Marketing is not yet finished. The task list run waits for someminutes and checks then whether replication is finished. If the replication is not finished the task list run is stopped and the error "Monitor your replication for ERP" is thrown. The reason therefore is that a replication can take several hours.

Please restart the task list run of "CUAN_SETUP_ERPCONTENT" after some time when you think that SLT sholuld be finished.

You can also log on to the SLT system and can verify the status of the configuration. If the replication of the configuration get stucked due to an error you have to correct the issue.

However, only after the SLT replication is finished the task list can be continued.

Hope this info helps you.

BR Axel