Skip to Content
avatar image
Former Member

IDOC Not reaching ECC from SAP PO

Hello All.

I am having issue while posting IDOC to ECC i have configured the receiver channel as below.

In the channel log I can see that its successfully processed idoc

And rfc destination mentioned above is also working fine.

I am able to ping it from SAP PO.

But still idocs are not reaching sap ecc.

Any suggestions where to check?

Thanks

Naveen

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • Best Answer
    avatar image
    Former Member
    Dec 24, 2015 at 04:15 PM

    Hi

    Thanks all for your help, the issue was that incorrect module name was there in receiver channel.

    I changed the module name to IDocOutboundModuleBean and processed the message ,it started reaching ECC.

    Hence closing this thread.

    Thanks

    Naveen

    Add comment
    10|10000 characters needed characters exceeded

  • Dec 23, 2015 at 01:29 PM

    Hi Naveen,

    Please check the transactions SMQ1, SMQ2, SM58, IDX5.

    Did u imported the meta data for IDOC?

    Please check the same thing in IDX2.

    and check port in IDX1.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Praveen Gandepalli

      Hi Praveen,

      Thanks, now i can see the IDOC in idoc monitor which are from ecc to po.

      But when i m sending idoc to PO to ECC,the idoc does not appear in idoc monitor.
      But the mesage is successful in communication channel and i can also ping the rfc destination mentioned in channel pointing to ecc.

      Can u please help if other settings are required to be maintain in ecc or nwa ?

      Thanks

      Naveen

  • Dec 23, 2015 at 01:21 PM

    Hello Naveen,

    check in SM58,IDX2.

    If no entry is there check the RFC destination in the channel.

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      HI Raghuraman,

      Its single stack PO server.

      In ecc SM58 i checked and there is no entry found.

      Regards

      Naveen

  • avatar image
    Former Member
    Dec 24, 2015 at 03:56 PM

    Hi Naveen,

    Please chnage the RFC destination name to "XI_IDOC_DEFAULT_DESTINATION_<ERP SID>" in channel .

    This XI_IDOC_DEFAULT_DESTINATION will be used for Sender IDoc channel and same is used to send acknowledgement to ECC i think that processed message came like that.



    Regards,

    Sateesh.

    Add comment
    10|10000 characters needed characters exceeded