Skip to Content
avatar image
Former Member

Evaluation class in T512W table

Hello,

In class evaluation 07 into T512W, I need to set two different values to the same wage type. Is there this possibility?

Regards,

Raquel

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    May 23, 2017 at 01:33 AM

    Hello Vinicius,

    Sorry for the delay. The "issue" was solved by development team with a tratament by an enhancement.

    Thank so much for your help.

    Best Regards,

    Raquel Almeida

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 20, 2017 at 04:36 PM

    Hello, Raquel.
    To consider the same value in more than one field on Income Declaration and DIRF report is necessary to create a new wage type and then configure it (T512W) with the required Specification of the Evaluation Class 07 (the first wage type had to be with the another Specification required). Then, create a new Personnel Calculation Rule (PCR) or maintain an existent one just to pass the value calculated of the first wage type to second one.

    If it's not possible to calculate the Payroll anymore before to delivery the DIRF report to government, you can do 2 possible solutions:

    1~ Design, to development team, an enhancement to sum this wage type (first one) on more than one field of DIRF (HBRDIRF1) and Income Declaration (HBRCCED0) report - with this solution, the second wage type mentioned is not necessary anymore;

    2~ Design with development team an customer ABAP apliccation (Z* / Y*) to add a new wage type (second one mentioned to be created) on Cluster RGDIR and tables - RT, etc - (yes, it's possible, not the better solution of all times, but it's possible);


    After all this steps, you'll be able to run and check your Income Declaration and DIRF report.

    Regards,

    Vinicius T. Ferreira

    Add comment
    10|10000 characters needed characters exceeded