SQVI Report

[Former Member]

Hi All,

While creating an SAP Quick Viewer, certain program selection screens had been wrongly selected.
The Quick Viewer had been saved with these program selections only.
Now if I want to remove the fields from the Program Selection portion,what do I have to do?
Please guide me.....

I have attached the screenshot,indicating the fields which need to be removed
These fields have been marked in a colored box

Best Regards,

Abhishek Pal

[former_member675104]

Hi ,

I am not sure if I have understood your problem correctly.

in SQVI.

1. Put query name , click on change

2. Go to Selection screen Tab

3. whatever fields you want to remove select and click on Remove field.

4. Save

br,

Dhiraj

[former_member187692]

Hi Abhishek,

   From SQVI, select your particular query and display it. Go to the 'Basis mode' - in that you can find

the " Selection fields " tab from where the selection-screen entries can be modified.

Here is a snap-shot:-   

Hope this should do.

Regards,

Naren K.

[jogeswararao_kavala]

Hello Abhishek,

It is understood that your SQVI is based on a Logical Data base. In LDBs some fixed Selection screen swill be there, which we can not change even if we want. These selection fields can be identified by the Greyed-out Selection field Tick on the left of the SQVI. See the picture.  Often beginners do not notice this and select same field from other table of this LDB. In the picture given such field EQUNR has been illustrated.  Selection field tick against Green arrow is System given Selection field tick against Red arrow is user's created Selection field (This appears in the Program selections screen area of the Selection screen).

Now it is repeating. So what to do to avoid repitition? Simply untick the user's selection (Un-tick the Red circle). It's done.

Hope you understood.

Good luck

KJogeswaraRao

[Former Member]

Yes I have succeeded in creating the query.
Thank you for the responses.

Best Regards,

Abhishek

[jogeswararao_kavala]

ABHISHEK,

Thank you for feedback. Because you've been answered you are supposed to close the thread.

How you close a discussion.

When you click on 'Correct answer' in any one of the received replies, you closed the discussion.

In case you felt, there was no Correct answer to your query and yet you want to close the discussion, then you click on 'Mark as assumed answered' below the title of your query. This too closes the discussion.

Also you may click on 'Helpful answer'  in the few received helpful replies at the time of closing a discussion.

Regards

KJogeswaraRao