POWL shadowing for Supplier pre selection

[former_member621691]

Hello Experts,

We are trying to enable POWL shadowing for Supplier pre selection POWL queries. We use SAP SRM 713 version.

Could anyone please tell which component configuration I will have to enhance? is it advisable to enhance the configuration?

the below screen shots shows the component name and the config ID -

But when i try to find /SAPSRM/WDC_SUCO_POWL in the component POWL_UI_COMP I am not able to find it.

Please correct me if am wrong. ( I doubt the config id is /SAPSRM/SRM_PSUP_I_01)

Also I went through the link

How to avoid query locks using POWL Shadowing - Supplier Relationship Management - SCN Wiki

And created a component config –

And an Application Config and assigned the above created component configuration to this through assign configuration name

Since we are using SRM 713 the manual steps in note 1118693. are already available.

Also have activated powl shadowing for the configurations specified in the above link -

Thank you,

Anish

[Former Member]

Hi Anish,

I am facing the same issue for Guest Logon in eTendering scenario.

Have you resolved the issue?

Can you please share how were you able to resolve the issue?

Thanks in advance.

Regards,

Mayur Khedkar

[former_member219695]

Dear Mayur,

Please check the following wiki to resolve your issue.

https://wiki.scn.sap.com/wiki/display/SRM/How+to+avoid+query+locks+using+POWL+Shadowing

Thanks

Shuvrajyoti

[Former Member]

Hi Shuvrajyoti,

Thanks for your response on this.

I followed these steps and it worked fine for Buyer login.

However for Bidder logon, I could not apply this since I could not find application SRM _B_ RFXANDAUCTIONS under POWL_UI_COMP to do the enhancement.

Can you help me to identify the exact location where I can do the enhancement for Bidder.

Thanks,

Mayur Khedkar

[former_member219695]

Hi Mayur,

Since you have created different thread ,request you to close this one.

Thanks

Shuvrajyoti