cancel
Showing results for 
Search instead for 
Did you mean: 

SQVI can't work

former_member397166
Participant
0 Kudos

Hi all,

     When I call transaction SQVI, it messages  'Convert first'.

Convert first

Message no. AQ898

Diagnosis

Before you work with queries, functional areas or user groups in this query area, you must convert the objects.

Procedure

Get your system administrator to convert the objects. The ABAP Query Release Information for Release 4.0A describes how to convert these objects. Also read Note 92124.

Thanks

Kical

Accepted Solutions (1)

Accepted Solutions (1)

david_liu1
Advisor
Advisor
0 Kudos

Hello,

As for the issue, you can run report RSAQUM40 with "Set release flag" and check again.

The answer is well-documented in SAP Note 92124.

Regards,

David

former_member397166
Participant
0 Kudos

David,

     Thank you very much!

Kical

Answers (1)

Answers (1)

pardhreddyc
Active Contributor
0 Kudos

Dear

Hope the query was created using transaction SQ01 which was moved through transport request.

Few queries are user specific.Kindly check that toO.

Kindly check below sap note also.

325829 SAP query: Message AQ898 after new installation

SAP Note:92124 clearly says:

Symptom

After a release upgrade from a Release 3.X to Release 4.y, you cannot maintain any query objects (queries, user groups, InfoSets, functional areas). Queries cannot be executed. In each case, the system generates a message:

    AQ898 ("Convert first").

This error message occurs if a new installation of an R/3 system was made on the basis of a Release 4.y.This error message may also occur if an IDES system was reinstalled.
For more information about this, see SAP Note 109094 as well.


Hope this may help you little bit.

Regards,

Pardhu