SSO config between NW portal 74 EP and ECC6 EHP6

[mandeep_kauldhar]

Hello Gurus, I am trying to configure SSO between NW portal 74 and ECC6 EHP6. My end task in hand is to enable a .Net based app connected to an ECC6 EHP6 system using SSO.

Below are the steps I did as of now; am I missing any step here in step 2?

I did following steps as per the document at below location:

1. SSO configuration

Single Sign-on with SAP Netweaver 7.3 and http://scn.sap.com/community/enterprise-portal/administration-and-development/blog/2014/10/30/step-b...

2. Create system object (say alias name ABC )as per guidance in document

http://wiki.scn.sap.com/wiki/display/EP/How+to+Create+System+Object+in+the+Portal+for+Connecting+to+...

I am facing this below issue in 'System object' test connection:

No connection to system <SID>CLNT800 found:
com.sapportals.connector.connection.ConnectionFailedException: Connection Failed: A nested exception occurred. Could not initialize physical connection.
Connection Failed: A nested exception occurred. Could not initialize physical connection.
Connection Failed: A nested exception occurred. Could not create JCO connection.
Ticket contains no / an empty ABAP user ID (see note 1159962)

Do I need to specify any user mapping provided I have same user in NW portal and ECC6 EHP6?

NOTE - I had a user mapping setup in user management before (same user in ECC6 system as in NW portal) through a ECC6 EHP5 alias system (say alias name XYZ ) which I deleted from the NW portal system objects along with the certificates etc. This is a brand new NW 74 installation.

I went through the sap note 1159962, I have already these setting ‘ume.configuration.active=true’ and basis release I have it 731 SP2 and Kernel release 720 patch 100.

I went through a number of scn threads but didn’t find any appropriate answer.

Any help is greatly appreciated.

Regards, Mani

[vijay_kumar49 · Accepted solution]

1. Did you pass all correct information while creating the System Object in SSO  ->

          Please take all the information from the BASIS-like Connection, WAS and ITS etc.   

2. if you have user Name and Password in ECC System. then only connection test should be work.

is it correct System ID: CLNT800. its wrong.

[mandeep_kauldhar]

Now after setting correct system for reference system and setting up user mapping in user records it works. but i am not able to see MYSAPSSO2 cookies in the cookies folder.

I am expecting cookie to be created once i hit an Iview created from resource system (say for Tcode SU01) but not able to see any clue?

Thanks

Mandeep

[vijay_kumar49]

On transaction RZ10 check parameter exist "login/accept_sso2_ticket = 1". in default profile. If not create a new one.

Also check MYSAPSSO2 service is active or not through transaction SICF.

Also do check SAP Note No. 817529.

The MYSAPSSO2 cookie