Skip to Content
avatar image
Former Member

Restart BPM

Hi everyone.

I have one big problem.

first of all, i have a BPM that runs for 1 week. During this week, R3 backend can be stopped in order to make a backup. Mi BPM has 3 ASYNC RFC call with another ASYNC RFC answer from the R3.

The problem that i've found is that when they start again the R3, my TCP/IP R3 channel didn't see the XI box, so i have to 'activate' again the XI sender RFC comm channel.

But my problems didn't finish here.

XI asks R3 if 'something' has been finished. Because R3 is 'down', XI won't have an answer, never.

So, the question is .. how can i restart the process exactle in the same step where was stopped?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    Feb 13, 2006 at 06:59 PM

    hi,

    if you cannot restart it from the r3 in any way

    you can always post the message directly to the integration server:

    RWB - component monitoring - integration engine

    test tab and paste the xml payload you want to send

    (you have to create the payload manualy and very carefully)

    Regards,

    michal

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi,

      you might want to see the following notes:

      772651

      749945

      801885

      70927

      However, please take into consideration following facts:

      1.- Workitems which have triggered an exception, which was handled, remain always as COMPLETED.

      2.- A restart will start the workflow from the step inmediately before an error took place.

      You can restart a workflow with report RSWWERRE.

      Regards, Jaime Farinos