Skip to Content

DMS Integration with Inspection Plan

Hello,

I would like to know if is possible assign a Inspection Plan (QO01) to DMS Document (CV01N)?

In DMS configuration (DC10) I can define a several object links, but I can't find a specific link to "Inspection Plan".

Can anybody help-me?

Flavio Molina

Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Best Answer
    avatar image
    Former Member
    Oct 30, 2015 at 09:06 PM

    Flavio,

    If you are attempting to add this to the inspection plan header, then I'm not aware of an object link that is available for it in DMS. However, you can attach a DMS document to an inspection method that you can then associate within the characteristic of an inspection operation within QP01/QP02. In that case, you would first make sure your document type has the inspection method object link enabled in the document type definition (in SPRO). Then you use QS31 to assign your DMS document DIR to the method. After that, you go into QP02 and add it to the appropriate characteristic within the inspection operation.

    Hope that helps...

    Richard.

    Add comment
    10|10000 characters needed characters exceeded

  • Oct 30, 2015 at 03:09 PM

    As far as my knowledge is concerned about DMS you can't! 😔 But if you are looking to assign some sort of drawing or specification sheet, you can attach the same in MM02.

    Anand

    Add comment
    10|10000 characters needed characters exceeded