Skip to Content
avatar image
Former Member

CRTD PASG SPRQ lot status

Dear Experts,

I have a issue with incoming inspection lots.

Case is as below:

I have Vendor : V and Material : M

one scheduling agreement - SA

done GR of SA to create lots.

1st GR done for M and V - Lot created IL1 with status : CRTD PASG SPRQ

After 1 minute,

2nd GR done for M and V - Lot created IL2 with status :REL CALC SPRQ QLCH

So the problem is with the first lot- why it dint come to REL status automatically

Even though the Material, Vendor, Inspection plan is same for both the cases.

Plan got assigned in both the cases but one was in CRTD status but other is in REL status.

We are using Dynamic modification rule also. i am not sure whether that would be linked with this thing some where.

Because in the first lot IL1 under "Plan assigned" tab - no DMR details appeared.

but in the second lot IL2- under the tab "Plan assigned" DMR details appeared.



Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • Oct 29, 2015 at 11:47 AM

    I don't think this has any correlation to DMR. Were there any changes made in inspection plan (such as change of sampling procedure) or in material master (such as ticking or unticking manual sample calculation checkbox) after the first lot creation but before the generation of 2nd? The 1 minute time duration between these 2 is so small but if you can confirm would be great!

    Until the exact reason is investigate and if this is happening only for this case then you can change the status in QA02. Click on Smpl. button in Sample tab. This will calculate the sample size and the lot status would change to REL


    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 29, 2015 at 11:55 AM


    Please check this link.

    Inspection lots with CRTD status- Causes and Remedies - Product Lifecycle Management - SCN Wiki

    Hope this would help to understand your exact problem.


    S Ahmed

    Add comment
    10|10000 characters needed characters exceeded