Skip to Content

Wrong batch no in Insp.lot

During reclassification of material we now have materials on Q stock with inspection lot.

This inspection lot points to the old batch that no longer exists on stock.

So the batch on stock is not the same as the batch in the inspection lot that its connected to.

So... is it possible to change the batch in the inspection lot?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Oct 28, 2015 at 10:16 AM

    What batch number do you see in MMBE transaction code? Is it not the same that reflects in inspection lot? Ideally this should always match. Batch is assigned to the inspection lot at the time lot creation and it is always the same with which Goods Receipt was made. So you can not change the batch in inspection lot. I would suggest to check if any material document was generated for that batch in MB51.

    Anand

    Add comment
    10|10000 characters needed characters exceeded

    • The rebatching was made in HUMO som movmt 309 reflects in mb51.

      The quant in WM (LS26) shows the batch... and wich inspection lot that is connected to it.

      If I then take that insp. lot to QA03 there is anouther batch in that insp lot.