Skip to Content

Short dump error during data extraction in ECC for classification datasource - CONVT_TO_NUMBER

Hi,

I am getting short dump error when running extraction checker with RSA3 .

I found below SAP NOTE with correction but it is no longer valid in our system as we are on a much higher support level.

Does any know how I can resolve the issue or know of any recent sap note.

Bhat

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    Oct 26, 2015 at 12:01 PM

    Hi Bhat

    The short dump shows some information about a value 'SP' cannot be interpreted as number which seems to be reasonable.

    Would you be able to check the underlying tables for this datasource to see if any issue with the data.

    Could you also please check and post the how to correct the error part and information on where the error occurred from your dump analysis page?

    If possible, restrict the extract checker by giving some small selection and see if it works, just to narrow down the reason.

    Regards

    Karthik

    Add comment
    10|10000 characters needed characters exceeded

    • Hi, We finally, found the rootcause. It was because on inconsistency in data types for a particular field that has the unit. The unit field in question does not exist in DEV so it inherited to data type property of characteristic. this field unit has now been created and datasource regenerated. thanks