Skip to Content
avatar image
Former Member

Not able to perform the result recordidng through QE01

Hi All,

when we are trying to do the result recording through the QE01 we are not able to do the recording and

we are getting the below error message which is shown in the  below screen shot.

Thanks

Bhagee.

pastedImage_0.png (57.2 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • Best Answer
    avatar image
    Former Member
    Oct 23, 2015 at 10:03 AM

    Dear Bhage,

    You have valid inspection plan, But no operations in your Plan.

    Without inspection plan PASG and CALC status not possible.

    Regards,

    Mahesh

    Add comment
    10|10000 characters needed characters exceeded

  • Oct 23, 2015 at 01:26 PM

    Since you haven't done the UD, you can reset the sample using QAC3.  This should put the lot bck in CRTD state.  Then go into QA02 and change the key date to TODAY's date.  Then click on the specifications tab and pick the plan, hit enter and sample should be calculated and status changed to REL.  Now see if you can record results.

    Craig

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 23, 2015 at 08:05 AM

    Dear Bhage,

    The problem is with your inspection plan.

    What is the system status of the inspection lot ?

    Regards,

    Mahesh

    Add comment
    10|10000 characters needed characters exceeded

  • Oct 23, 2015 at 08:38 AM

    Hi Bhage,

    Please check QP03 whether that material has inspection plan or not..

    If the material doesn't have inspection plan means the status of the inspection lot will become CRTD in that situation we will not be able to make any results

    so please check in QP03 and assign the same in QA02

    Regards,

    Venkatesh..

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Bhage,

      Yes what you said is correct if the inspection plan validity is not valid on lot created date means system will not capture the Task list details

      so please check the plan has been copied or not

      in QA02 -->Inspection specification --> Task list / Spec

      if not there please change the key date as 10/22/2015

      then click on Task List / Spec system will capture the data

      Regards,

      Venkatesh..

      Plan.JPG (41.2 kB)