on 10-23-2015 1:31 AM
I using visual studio 2010 and crystal report 11 rel 2.
Some of my report does not filter data based on where clause I passed at run time. I am passing a where clause at runtime using following statement to set my where clause.
crRepDocument.RecordSelectionFormula
It is strange that where clause works for some reports. I use same routine for all my reports that sets where clause to the report.
XI R2 was never supported or tested in VS 2010.
Upgrade to CR for VS, installer and redist packages are on this page:
http://scn.sap.com/docs/DOC-7824
Don
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
101 | |
13 | |
13 | |
11 | |
11 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.