on 10-20-2015 6:37 PM
Hi All,
We are using SMP server 3.0 SP07 with service manager 4.2 application.
We get session time out error every time if there is a slow connection and works fine if there is a better connection.
Please share that at what all places we should increase the time outs, session time outs and keep alive time outs in SAP Management Cockpit or Application or client.
Please suggest. Thanks in advance
Thanks
Neha
Hi Neha,
Apart from the timeout parameters within Application Configuration I would also suggest you to check how the users are connected to your corporate network. If it is trough proxy then the proxy itself might have timout. We had a similar case in which we finally found the Proxy timeout to be the culprit to break the transmission. This could be verified by Network administration team.
Regards
Vinod
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Vinod,
Thank you, I agree we should increase this time as well.
Also, our application runs on the DMZ network and its accessible from out side the corporate network or we can say we can connect the client with server in public network.
In this case also can we maintain the proxy time outs?
Thanks
Neha
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
The idle timeout, is for locking the client out after X time after the user hasn't used the device. This is not to be used for increasing the transmit timeouts.
To increase the transmit timeout, go into the cockpit under the application. Go to the "App Specific Settings" and you need to increase the following section key:
Server -> InactiveTimeout
User | Count |
---|---|
95 | |
11 | |
11 | |
10 | |
9 | |
8 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.