Skip to Content
avatar image
Former Member

BAPI for LI12N to change PI count

Hi all,

I'm trying to figure out Physical Inventory process in WM.

The only BAPI I could found is L_INV_COUNT and L_INV_COUNT_EXT. And as I see, they are same.

Whatever, I need to change count documents by BAPI. Is it possible? Same function with LI12N transaction.

Thanks.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Oct 19, 2015 at 11:42 AM

    Hi Sefa,

    Do you get any issue while using the function module L_INV_COUNT_EXT because from earlier cases I could find this might be helpful in your case.


    If you are getting any issue/error while using this function module, then could you please specify that as well.


    Thanks & regards,
    Balaji

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi,

      The FM is checking whether PI document is counted. If yes, It gives error like below:

      LK 036

      Check your entries. Inventory count already complete or not available

      I checked the LI12N transaction and FM itself. Both of them use FM L_ZAEHLUNG_BUCHEN to change quantity. So I think, I should use this also, or I can copy L_INV_COUNT_EXT and make Z FM.