Skip to Content
avatar image
Former Member

Configure CA Willy Introscope

Hi all

I am no performing New installed Solution Manager Basic configurations and have some problems in Wily introscope installation guide(vers 9.5).

Automated Installation of the Introscope Agent via SMD

4.Launch the Introscope Setup application: SAP Solution Manager Configuration -> Managed Systems Configuration -> Step 7 Configure Automatically-> Automatic Activity “Byte Code Adapter Installation” -> “Open Java URL” (only available in edit mode). Your screen will look similar to the image below:

In my screen there is no introscope agent. The screen is attached.

What can I do? Any information will be helpful.

Best regards

Aram

Untitled.png (34.3 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Oct 15, 2015 at 04:21 PM

    Hi Aram,

    What do you see when you click on the drop down? Do you see your JAVA systems?

    Regards

    Aditya Khorana


    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Aram,

      The error you are getting because either your EM is not working or the port is not open. Is the EM installation on the same host as Solution Manager or other host.

      If its on the same host go to /usr/sap/ccms/ampintroscope/bin and run ./EMCtrl.sh status and confirm the same

      If the installation is on a different host than solution manager, you will have to first check EM is working or not. If yes, then see if you can telnet port 6001 from the solman to Wily Introscope host.

      Regards

      Aditya Khorana

  • avatar image
    Former Member
    Oct 15, 2015 at 06:30 PM

    Dear Aram,

    As you are completing a fresh install, I am unsure of the current configuration status of your system.

    But, in general please double check the following:

    1. Step 2 from the sequence of steps you have referenced has been followed:

    "Deploy ISAGENTJ5*.SCA which is the Introscope Java Agent 9 with SDM to Solution Manager.
    You may need to deploy also ISAGENT*.SCA which is Introscope Java Agent 8."

    Please also ensure to enable and disable Maintenance Mode before and after the ISAgent deployment

    2. The Enterprise Manager is selected in the 'common parameters' window of 'Enter System Parameters' in MSC

    NB: If your system uses Java 1.5 and up then Java Agent 9 will be used, otherwise Java Agent 8 will be used.

    Best regards,

    Neal

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Neal

      Here are the steps that I have done.

      I open Java URL where in system preparation I turn off maintenance mote for agent connection and turn on maintenance mode

      and turn on maintenance mode

      than in os level I open /usr/sap/<>/<>/SDM/program/RemoteGui.sh

      afterwards I insert sca file that I have downloaded from SAP(ISAGENTJ515P_3-10010975.SCA ISAGENTJ506P_1-70000124.SCA ISAGENT24P_2-20006926.SCA) click next and receive this message

      click ok

      start deployment

      confirm.

      When I go to undeployment tub, I can find dhe packages that I have deployed

      Than again I turn off maintenance wait for a minute for agents initialization.

      I  have already installed agent version 8 but nothing changed.