PO output for PORDCR1.PORDCR102

[Former Member]

Hi Gurus

We are using PORDCR1 idoc to send the PO output to SNC. I have set up distribution model and NACE config as mentioned in thread

https://scn.sap.com/thread/3383983

However instead of maintaining PO output condition record for output type with spl function as medium, the output is not getting generated in PO after saving the PO. I need to enter output conditions in PO manually and then the idoc getting created.

Please help me if I am missing any other setting?

Will appreciate your early help

Thanks

Vipin

[Former Member · Accepted solution]

Hi V_SAP K_SAP,

There can be 2 different reasons for the resolution of the problem. Firstly i can unsure that this is related to SNC output configuration settings:

1- You can check the below customizing under t-code EL --> Your output condition:

You need to ensure that below check is not exists:. "Manuel only line should not be there.

2- Kindly make the we20 settings like below:

Do let me kow the results...

Regards,

Selim Batur