You cannot select field xxx in the source

[Former Member]

Hi colleagues,

While transporting DTP, I'm receiving following error message:

"You cannot select field xxx in the source

Message No. RSBC201

Diagnosis..."

Mentioned field is available in the source and is part of a key. Also, this field was always loading properly.

Do you have any ideas about the reasons for that?

Thank you,

Nik

[RamanKorrapati]

Please see this OSS Note 1023113:DataSource: You cannot select "Transfer" property for field.

at ECC side, RSA6 - Have you done any selections for your data source fields(xxx)? if yes then please undo them and save/activate data source.

Later transport your ECC Data source to ECC Qua/Prod.

After that you can replicate ECC Qua/Prod data source to BW Qua/Prod respectively.

Next you can move active bw dev data source to BW Qua/Prod servers.

After that you can transport your target, transformations, info pack and dtp thru each requests.

[Former Member]

Hi  Ramanjaneyulu,

Thanks you for your answer.

No, I'm not doing any selection on that field. It looks exactly like other fields in RSA2 and RSA6.

Cheers,

Nik

[RamanKorrapati]

Can cross check about the field(xxx) which is mentioned in error message.

Why its showing that field only? there might be something changed  respective of that field.

so please check about that field and retransport whole data flow from Dev to Qua/[prod.