Problems w/ ISO Code when creating planned orders

[Former Member]

Hi everybody,

I developed a program that runs BAPI_PLANNEDORDER_CREATE, and it returns an error for some materials:

Measurement unit FRC has no ISO code

I went to T-code CUNI and included this ISO Code, but the error continues.

I tried to create it through MD11 and it is ok, the planned order is created without any issues.   

Any ideas on why this is happening? There is any other configuration I'm missing?

Thanks in advance,

João Bitar

[JL23 · Accepted solution]

Just adding the ISO code in the ISO code step of CUNI is a step too short

You have as well to assign your new ISO code the unit of measure in CUNI

[Former Member · Accepted solution]

Hi Jürgen,

Thank you for your reply, but I already did it.

Could you tell me if there is any other step to do?

Best regards,

Bitar

[JL23 · Accepted solution]

This screenshot does not show that you have assigned the ISO code to the unit

Please select and go into its detail, assign it there and select the primary code field

[Former Member · Accepted solution]

This is correct, Jürgen, thank you very much!

[Caetano]

Hi João

I have never seen this error before. Maybe you could check in debug using the procedure from the blog below:

BR
Caetano

[Former Member]

Thanks, Caetano. I'll try that.

Best regards,

Bitar