Skip to Content
avatar image
Former Member

Port mismatch in idocs

Hi All,

There was a port mismatch previously inecc, so theidocswheregenerated with the status code: 02. I have assigned the exactport in we20 outbound parameters and corrected in we21.

Wheniam reprocessing the sameidocnumber with status 02 in "bd87",itsgoingwiththe previous port whichihave deleted.

When iretrigger it by changing the port its success with status code 03.

What changes need to made forthis settings, because ihave completely deleted the previous port which was assigned...we are using pi single stack.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Jul 23, 2015 at 12:13 PM

    Hi Ram,

    The failed IDOC will have the deleted port in its Control record. Even though you have deleted the port, but you are triggering from BD87 with the same IDOC which has still the old port. Hence it might be coming like this.

    Can you check now by triggering a new IDOC and check the outcome.

    Regards

    Add comment
    10|10000 characters needed characters exceeded

  • Jul 23, 2015 at 12:53 PM

    the other way you can reprocess idocs is from WE19 however you need idoc number for this.Once you have idoc number edit the port from theĀ  control record however this t-code will be restricted in Production environment.If you have access give a try to post one idoc and see if it works or not.

    Thanks

    Add comment
    10|10000 characters needed characters exceeded