on 07-14-2015 6:12 AM
Hello Expert
this is a question to all who have already active SCM_SNC_GEN2
I was also planning to activate SCM_SNC_GEN2, in my system
I was to use this to update Bill of lading and Carrier name at the time ASN
I don't want to use any other functionality ...I would like to know following
Regards
Manas Malhotra
Hello Folks
Thank you for your reply
the thing is have already conducted the test for BOL and Carrier ID; my issue was related to massupload of ASN using upload and down load centre
where if you have not activated GEN2 ; BOl and Carrier ID as fields are not available in the download file
So wanted to know what are the effect if I activate GEN2
I did try it out , and there are no issue reported as such; there are some new XML that can also be used for PO collaboration etc
But in call I found no issue
Thanks for your help
Regard
Manas Malhotra
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Manas,
Please find my answers below:
1. BOL & Carrier name will be sent to ECC at the time of ASN. You can find them in Inbound Delivery. You may need to activate Validation checks to make BOl & Carrier Mandatory while publishing ASN.
2. Normally no new setup is required. Please check PI mappings in case you are not getting it in ECC.
Regards,
Rahul Sharma
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello,
1. Yes the data on the WEB UI ( i.e Bill of Lading) will be updated on the ECC side on the inbound delivery.
2. Would need to see my details, but I don't believe so.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
8 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.