Sample size and sample procedure

[former_member221822]

Hi QM experts,

There is a inspection plan, and have two MIC: Characteristic_A and Characteristic_B, but different sample procedures.

Characteristic_A        SampleProcedureA: inspect 10%

Characteristic_B        SampleProcedureB: inspect 20%

And we can see the sample size in QA03. I want to know How to calculate this sample size? By inspect 10% or 20%?

Thanks.

Regards,

Steve

[Ayoub_Habchi · Accepted solution]

Hi Steve,

The sample size will depend of some configuration made at the MIC level.

For example, if the check "Additive" is not checked for both characteristics, the system will take the MAX of the two sample sized (ie 20%).

If one of the two is marked as additive, then the system will use 30% (20%+10%) because the additive characteristic sample cannot be used for other characteristics.

Hope this clarifies your issue.

Let me know if you have any other question.

Regards,

Ayoub.

[former_member221822 · Accepted solution]

Hi Ayoub,

Got it. Thanks a lot.

Regards,

Steve