Skip to Content
avatar image
Former Member

Error in executing the Integration scenario -Please be specific in your answer

I am running the SOAP to SOAP Integration scenario, while running that it gives error in the operation mapping step. Please find the attached screenshots.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

5 Answers

  • Jul 08, 2015 at 10:45 AM

    Hello Naveed,

    Please check the following if it helps:

    1. Cache status of ESR and ID

    2. Do some dummy changes in OM and activate

    3. Try with valid payload in test

    4. Did you try End to End testing?

    Regards,
    Azhar

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jul 08, 2015 at 10:49 AM

    HI,

    First put the valid payload.

    It looks your interface is not able to find the resource as per attached screenshot.

    Try after doing cache refresh going to SXI_CACHE.

    Regards,

    Dipen.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jul 08, 2015 at 10:41 AM

    Hello Naveed,

    Did you put a valid Payload.

    I would suggest, go to ESR and test the Operation Mapping.

    Regards,

    Kalyan

    Add comment
    10|10000 characters needed characters exceeded

  • Jul 08, 2015 at 10:45 AM

    Hi Naveed,

    Go to message mapping WS_To_WS_IM and do a dummy change like to change the description.

    Do your test with a correct payload, take the payload form the message or operation mapping request and set it in the ID test tool.

    Pay attention this tool is only useful with the classical configuration with sender agreement, receiver determination and so on. It is no useful with the ICO object.

    Also, you can try inside PI from runtime workbench and wsnavigator tool.

    Regards.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jul 08, 2015 at 05:25 PM

    Hi Naveed,

    From the screenshots which you have provided, it seems you are trying to convert attachment into payload. Because of this failure, the specific error is coming.

    In order to convert an attachment into payload, you must use the Message Transformation Bean "PayloadSwapBean".

    Please have a look at the below link for reference:

    Adding PayloadSwapBean in the Module Processor - Adding Modules to the Module Processor - SAP Library

    Regards,

    Souvik

    Add comment
    10|10000 characters needed characters exceeded