cancel
Showing results for 
Search instead for 
Did you mean: 

Is it possible to input batch number in STO?

Former Member
0 Kudos

Hi Guys

    I have a question about batch number and STO.

    Is it possible to input batch number in STO? I couldn't find batch number when i select UB type in ME21N.

    I go to screen configuration and select batch to delete from invisible fields.but semms it doesn't work.

Accepted Solutions (1)

Accepted Solutions (1)

former_member183424
Active Contributor
0 Kudos

Please read my blog post and check the field selection key UBF (batch field is under field selection group 'GR/IR Control').

If you set this field as hide from field selection, then you can't make it visible from screen configuration.

Answers (3)

Answers (3)

former_member188914
Contributor
0 Kudos

Hi Bruce,

Once you tick mark batch field to 'not be' invisible and you again goto same setting but you see that your changes are not saved(meaning the field is again marked for being invisible). Correct ? Refer this note 120901: Hiding of columns by table control is not possible and 329437: ME21N: Functions not available. Will be helpful to you.

Regards..

JL23
Active Contributor
0 Kudos

The batch field only appears if the material is batch managed, there is no other reason to display this field.

Former Member
0 Kudos

You should not delete from Invisible fields rather just remove the tick mark and check the batch field appears as input.