Skip to Content

Error in SOAP Response: SOAP Lookup

Hi All,

I am Integrating SFDC using PI 7.31 (Single Stack). Getting error in SOAP lookup channel " Error in Response" ,

I have created Sync dummy scenario in PI and triggered message from SOAP UI, It was working fine, same Receiver channel has been used in SOAPlook up code and still dummy scenario is exist in ID.

Java Code: Check1 was appeared in Trace but not check2 while executing Operation Mapping, seems there is a issue with an accessor call.

SOAP Channel Error:

Regards,

Mani

Capture.PNG (22.3 kB)
Channel.PNG (3.5 kB)
Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

3 Answers

  • Jun 23, 2015 at 12:16 PM

    Hi All,

    Any suggestion for the above issue?

    Regards,

    Mani

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jun 23, 2015 at 01:11 PM

    Hi Manikandan,

    Please cross check whether there is any issue with the receiver channel you are using for lookup purpose and also please cross check the input data you are providing for the lookup.

    Is this the first run for the interface?

    Please cross check with the SFDC team about the request format they need.

    Regards

    Vishnu

    Add comment
    10|10000 characters needed characters exceeded

  • Jun 23, 2015 at 01:53 PM

    Hi Manikandan,

    According with this blog SOAP Lookup from UDF, it seems the variable payload should be XmlPayload instead of the type Payload.


    Regards.

    Add comment
    10|10000 characters needed characters exceeded