Skip to Content

sap ehs expert rule -dapec and clean water act rule

I was trying to run dapec expert rule ? does anyone knows the prerequisite data to be maintained in specification before running this rule ? Also help me with clean water act rule as well

Add comment
10|10000 characters needed characters exceeded

4 Answers

  • Best Answer
    Posted on Jun 25, 2015 at 09:37 AM

    Hi,

    I guess the question is anyway why DAPEC is still needed now that GHS is relevant in Europe...

    Regards, Michael

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member krishna gautam

      Hi Krishna,

      You can not modify rules delivered by SAP EH&S Regulatory Content as the come compiled and you can not see the source code! You would need to write a rule from scratch....

      Maybe other content providers provide the source code of their rules but I'm not sure on this.

      There used to be training available from SAP for writing rules but this is AFAIK no longer the case - but please re-check with SAP.

      SAP help provides some basic guidance:
      Using the Rule Editor - EH&S Expert - SAP Library


      Hope this helps

      Mark

  • Posted on Jun 15, 2015 at 06:13 PM

    Hi,

    Technically not a one word answer, but will try to add some of my suggestions:

    These are rules based on one factor, such as composition, if any changes to the product composition of a preparation the standard composition as to be recalculated through composition rules and these changes will impact on all classifications data of the product, so its is necessary to recalculate the EU classification DAPEC.

    The Clean Water Act (CWA) is the primary federal law in the United States governing water pollution.Passed in 1972, the objective of the Federal Water Pollution Control Act, commonly referred to as the Clean Water Act (CWA), is to restore and maintain the chemical, physical, and biological integrity of the nation's waters by preventing point and nonpoint pollution sources, providing assistance to publicly owned treatment works for the improvement of wastewater treatment, and maintaining the integrity of wetlands. (Source Wiki).


    So we have some standard rules provided from the content provider which we run on our products.


    --

    😊



    Add comment
    10|10000 characters needed characters exceeded

  • Posted on Jun 17, 2015 at 07:46 AM

    Hi Krishna,

    DAPEC- Used to determine the labeling and classification info in regulatory info(chap15) of MSDS and Hazard inducing components in chapter composition.

    Its done according to dangerous goods directive for classification.

    standard composition to be maintained.

    user exit, user exit category,specification category and FM to be configured.

    I am not sure of the other rule.

    Hope it helps

    Thanks

    george

    Add comment
    10|10000 characters needed characters exceeded

  • Posted on Jun 22, 2015 at 05:40 AM

    Hi Krishna,

    input data for CWA are on product level the standard composition and on component level the CWA listing. That's a fairly easy one.

    Ralph

    Add comment
    10|10000 characters needed characters exceeded