Skip to Content
avatar image
Former Member

batch consideration in BOP


Our requirement for BOP is it should not consider the given Batch in sales order. Based on available stock it should give commit.

Any suggestions highly appreciated.

Thanks & Regards,

Bala B.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Best Answer
    Jun 13, 2015 at 10:40 AM

    Hi Bala,

    That's the standard behavior of the standard system to check at the lowest level if mentioned in sales order. Example if your SO is at plant level only then it would check at this level, If it's with plant and storage location then check would be at storage location instead of plant level and results could be different as plant might have three Sloc with more quantity. Same applies for batch which again is further lowest level as it is checking for specific batch in that storage location.

    If you want this check to be at plant level then keep your sales order at this level itself else you will have to check for exit/badi to do this. Using exit/badi then needs good amount of testing as results might be over-confirmation etc. coz batch might have less quantity but plant stock would be more.

    Check SAP note

    376773 - UserExit EXIT_/SAPAPO/SAPLBOP_FILT_010

    377186 - Backorder procg: User exit EXIT_/SAPAPO/SAPLBOP_SORT_020



    Message was edited by: Rahul Handa

    Add comment
    10|10000 characters needed characters exceeded

  • Jun 27, 2015 at 05:03 PM

    Hello Bala,

    In that case, did you try to manipulate the batch number from the CIF queue while getting posted into gATP system. Wouldn't that solve your issue ?

    Thanks & Best Regards,

    Babu Kilari

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member


      We have achieved this scenario by doing customization in ECC.Batch determination is done in ECC itself. So, we have applied the logic at the time of batch determination in ECC for a sales order.


      BK B.