Skip to Content
avatar image
Former Member

What needs to be done if hit ratio in ST02 is below 90% and there no not much swaps?

Hi There,

My doubt is if the hit ratio is low though there are no swaps what should be done in this case.

Please answer to this question in detail if possible.

Best regards,

Bhushan

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Jun 15, 2015 at 01:28 PM

    Have you tried lowering the value of that parameter?

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jun 19, 2015 at 02:55 PM

    Hi Bhushan,

    You need to check the parameter values and compare it with the swaps which you can get from the history.

    paramters to specific buffer can be seen by clickng the parameter button.

    If the system is started the hit ratio would be comparitevly less initially until the datas are load to buffer.

    Would be good if you can share the ST02 screen shot.

    http://www.sap-perf.ca/run-sap-st02-memory-monitor/

    Regards

    Nikhil

    Add comment
    10|10000 characters needed characters exceeded