activate source system

[Former Member]

Hi,

When I wanted to activate a source system after creating it, it displayed 'Message no. RSAR011', this source system linked to R/3,my R/3 has 2 client(100 and 200),it linked to 200.What's the reason?

Thanks.

[edwin_harpino · Accepted solution]

hi,

your source system created refer to which client ? the source system rfc establish well ? the rfc name should same as the logical name of the r/3 client.

hope this helps.

[Former Member]

Hi,

Make sure that your RFC connection is tested successfully from both the systems. If the other system does not have onr of the systems, create it and test.

My problem was that each time i tried to activate, activation would terminate due to non-existing RFC. So, I created it. Eg; Dev can test connection to Prod, but could not test from Prod to Dev.

Hope it helps, good luck.

[Former Member]

Hi dear,

what does the message say ?

What is the procedure you followed to create this source system ?

Let us know !

Bye,

Roberto