Skip to Content

Problem when clicking workitem from inbox

Hi,

I am calling VKM3 Transaction from BO ( for releasing the credit block ) and I checked the same in BO level , it is working fine. But when after running the workflow, when user clicking the workitem for release the VA02 transaction is opening. Actually it has to open the VKM3 transaction .

I am calling the transaction using the parameter id. both the VKM3 and VA02  parameter id is same. I checked the authorization and the user has the authorization for VKM3. Please find the attached code 

Please share your thoughts regarding this issue.

Regards,

Shamsudheen.

vkm3.PNG (4.2 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    May 19, 2015 at 06:45 AM

    Put a breakpoint to the code and test again. If another transaction gets called than the code implies, then for me it sounds like some other method is getting called, and not the one that you are expecting.

    Reason could be for example: Your test cases area already using some older workflow version that still has the old transaction etc.

    Regards,

    Karri

    Add comment
    10|10000 characters needed characters exceeded

  • May 19, 2015 at 07:31 AM

    Hi,

      Are you sure user is clicking on right workitem? please check

    Add comment
    10|10000 characters needed characters exceeded

  • May 19, 2015 at 08:14 AM

    Hi,

    First of all make sure that your assumption is correct. Use the workflow log to find out exactly which task was executed and what  the value was of the containers that were sent to the method.

    Then debug the method with these values and see what happens.

    Kind regards, Rob Dielemans

    Add comment
    10|10000 characters needed characters exceeded