No relevant partner system XXXXX exists for output category COND_A

[Former Member]

Hi guys,

We are trying to configure Hybris for the Async for Pricing conditions, everything is set up but i cannot send the conditions trough VK13 because of this error.

No relevant partner system JPARDDH5 exists for output category COND_A

We had set up the following:

WE20

BD65

SALE

SM59

Cannot figure this one out, could you help me please ?

[Former Member · Accepted solution]

Got it, we had to configure an extension in Hybris and it's okay now.

IDoc sent by HTTP in XML format

Message no. EA095

Diagnosis

The IDoc was sent by HTTP to the following address:

http://10.95.1.103:8794/datahub-webapp-5.5/v1/idoc/receiverHTTP Response Code:200

[DAcker]

Which extension had to be installed? I got the same error trying to replicate material data (MATMAS_CFS) from SAP ERP ECC to SAP C4C.

[Former Member]

Now i Got this message when the iDoc is transmitted and received  by the datahub.

Error when sending by HTTP

Message no. EA096

Diagnosis

When transferring the IDoc by HTTP, the return code with the message '400Bad Request' has occurred.

The target address was: http://10.95.1.103:8794/datahub-webapp-5.5/v1/idoc/receiver

Check whether the IDoc can be sent again.

It is unfortunately not possible to determine automatically whether the IDoc has in fact arrived in the target system and the error occurred afterwards.

Procedure for System Administration

Inform your system administrator

[Lakshmipathi]

Have a look at this

Creating Partner Profiles for Logical Systems - Interface for ATA SPEC 2000 and AECMA SPEC 2000M - S...

G. Lakshmipathi

[Former Member]

Did everything by the book and every setting is like from your link and the same error.

[Shiva_Ram]

Can you double click on the massage and provide the message number?

Regards,

[Former Member]

The message number is Message no. VJ000

[Shiva_Ram]

In the partner type configuration, can you change the value in the field Type from A to US -User and test again? I think it should not be work center.

Regards,

[Former Member]

Done that but the same result....

[Shiva_Ram]

So then next option would be, you need to debug the function module ALE_MODEL_DETERMINE_IF_TO_SEND in the program RV12L000 . Set the break point and see the values that getting exported for partner system.

Regards,

[Shiva_Ram]

Also check the classification tab of the partner profile.  The partner status is set to A - Active.

[Former Member]

It is set to A and this is the function output.

[Shiva_Ram]

Looks ok to me. what is the result when you click on the check button on the partner profile in WE20?

Regards,

[Former Member]

The output is the following with 1 warning

Message no. E1135

Diagnosis

For this outbound processing entry, there is no corresponding entry for message control.

System Response

If you trigger the message via message control, this entry will never be used.

Procedure

If you do not use message control, you can ignore this message.

[Shiva_Ram]

Can you check with t.code BD64 as mentioned in the link

Regards,

[JL23]

Is your distribution model active today? double click the icon with the 4 arrows to see in the details from when to when it is set active.

[Former Member]

It is active, when I try to generate the profile it gives me this.

The Port is created correctly but somehow it cannot be generated trough partner generation

[JL23]

so it means the WE21 step is missing

[Former Member]

It is not skipped, sadly...

I got an iDoc created but we have a problem with the port, so that's what I'm after.