Skip to Content
avatar image
Former Member

Getting error while try to open SAP system from GUI

Hi All,

When I try to open any SAP system from GUI I am getting below dump error message. Please suggest on this.

Thanks  & Regards

Surender

System error.jpg (83.3 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Apr 03, 2015 at 06:10 AM

    Hi Surender,

    Please check this old sap note

    http://service.sap.com/sap/support/notes/116042

    If you use old SAPGUI release or version without patches - update to 7.30/7.40 version and install the latest support package.

    Best Regards,

    Aleh

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Alen,

      I have installed latest version and latest support package also but still I am getting same error.

      Regards

      Surender

  • Apr 03, 2015 at 10:18 AM

    Hi Surender,

    Is it a general user issue or are you the only user facing that issue ? Does the error occur right after you enter user/password ?

    From the GUI session status bar, I see " Memory Low. leave the transaction before taking a break".

    This looks like a improper memory configured system. I would suggest that you review your memory parameters as per the SAP note 146289.

    If you already have the memory parameters set to at least the values suggested by that note, please further increase the parameters below:

        abap/heap_area_total

        abap/heap_area_dia

    Hope that helps.

    Kind regards,

    Eric

    Add comment
    10|10000 characters needed characters exceeded

  • Apr 20, 2015 at 07:01 PM

    which SAPGUI version are you usng?

    which patch level you are using?

    Add comment
    10|10000 characters needed characters exceeded