on 01-16-2006 3:33 PM
Hi Folks,
i have an active process chain in the test system. It is triggered by some event, which i am not aware of. If i want to manually trigger the process chain right now, how do i do it???
Thank you
Southie, if your Process Chain is triggered by an event, you can trigger the event manually using transaction SM64. This will execute your Process Chain.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
HI,
you have to change the startprocess to immediately. Save it then activate and execute the process chain.
BUT: You will loose the settings for the event then. So to be sure go to the start variant, change it, press after event tab strip, make a copy of this entry and the selected event. After you have triggered the process chain you can reenter the event and reschedule the process chain.
Regards,
Jürgen
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi,
if you set the start process with certain time (run in background), i think you can change the job to run immediately (transaction sm37). hope this helps.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
81 | |
10 | |
10 | |
9 | |
6 | |
6 | |
5 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.