Skip to Content
3
Mar 19, 2015 at 12:21 PM

Change configuration profile for material variants

3606 Views

Hi All,

I have a KMAT and some configurated material variants (FERT) assigned to the KMAT with proper configuration.

When I create a new configuration profile for the KMAT and lock the old one in CU42 then CU50 is ok and taking the new configuration profile for the KMAT.

However for the material variants which were already assigned I get the following error message in CU50:

No configuration profile selected for configurable object KMAT

Message no. CX005

Diagnosis

You entered a material that has no configuration profile, or the configuration profile is not released.

Procedure

Either create a configuration profile for the material or check the status of the configuration profile.

In MM03 when I click on the Configure variant button on Basic Data II or MRP3 view I get this message:

Specify a valid configurable material

Message no. M3544

Diagnosis

The system could not perform configuration value assignment for the configurable material specified. If you have not yet created configuration parameters for the configurable material, this may be the reason.

Procedure

Check your screen and field values.

Create configuration parameters for the configurable material or enter a valid configurable material.

How can I change/update the material variants to use the new configuration profile?

Best regards

Tamas