cancel
Showing results for 
Search instead for 
Did you mean: 

Identity Management configuration - Data link shows 2 IBM OLE DB Provider DB2

Former Member
0 Kudos

I'm configure a new Identity Manager configuration; working through the steps from MMC:  SAP NW Identity Manager (right click) > New > Identity Center configuration.   At the popup .. Connection String (...) the popup shows 2 IBM OLE DB Provider. I selected one and successfully  with "Test Connection'; then followed the rest of the prompted screens.  At the end, MMC was created but with error message " The Identity Center was unable to determine the type of database you are using. It will not possible to use Identity Center"

In the "Version Info" tab it shows "Detected DB - Unknown"

This on Windows 2008 server,  IdM 7.2 and DB2 database v 10.5

Any help is gratefully appreciated.

Phuon

Accepted Solutions (1)

Accepted Solutions (1)

former_member2987
Active Contributor
0 Kudos

Hi Phoun,

Well 7.2 should be capable of working with DB2.  What SP of IDM 7.2 are you using?

I'd recommend double checking the DB2 configuration setup against this document.

Good luck!

Matt

Former Member
0 Kudos

Hi Matt,

Thank you for your advise.  Correction my environment,  NW 7.31 AS Java  and DB2 database is on Linux server. The Windows server runs other IdM components (Designtime, Runtime, VDS ..).

We have IDM 7.2 SP7.

The DB2 config look okay. Another thing that after IDM database was created; we overlay-ed the IC_DB on Linux (target system)  with a working IC_DB database from another (source) system and adapted the table  IC_OPER.MC_GLOBAL_VARIABLES  to fit with our target system.

Thank you again.

Phuon

Update:

After verified the DB2 Server/Client configuration settings are correct according to Matt provided doc-link. we're still experiencing the same error.

Un-install IDM and Re-install IDM  that did not help either. 

Final Update:

After exhaustive checked and verification; I uninstalled IDM on Windows, cleanup all IDM directories and started from scratch. I also made sure that  my id on Windows server has full administrator rights, JVM and Paths correctly set.

The re-installed completed clean and MMC configuration for IDM was successful.

Thank you all.

Phuon

Answers (0)