Dump Error When Creating New Model in BPC 10.1 NW

[kyung-rak_lee]

Hello,

I Try to create New model with BPC 10.1 Admin .

But It ends with Error .

And In ST22 I can see Dump Errors.

Does anybody know about this problem?

Thanks in advance .

[chuan_ding · Accepted solution]

Hi Kyung-Rak Lee

This might be a known issue, can you implement the note below and then try again?

2122634 - A system dump occurs trying to create an InfoCube via BPC

Best regards,

Chuan

[kyung-rak_lee · Accepted solution]

Thanks for your answer.

I just knew that I couldn't find ENVIRONMENTSHELL in my System.

Is this can be the cause of Dump Error ?

[chuan_ding · Accepted solution]

Hi Kyung-Rak Lee

You must activate ENVIRONMENTSHELL in your system.
But "Unable to create model" with CALL_FUNCTION_REMOTE_ERROR might be another issue which need to implement note 2122634.
Can you please try again after activating ENVIRONMENTSHELL and implementing note 2122634?

Best regards,
Chuan

[Former Member · Accepted solution]

Hi Kyung-Rak,

You need to activate environmentshell, follow the install guide below:

SAP Business Planning and Consolidation 10.1, version for SAP NetWeaver – SAP Help Portal Page

Andy

[kyung-rak_lee · Accepted solution]

Problem Solved with note 2122634 .

Thanks.

[former_member432765 · Accepted solution]

Dear chuan,

I met an error when create a new model, and there is no error log by transaction code"ST22",please give me a help,thank you!

[former_member200327]

Can you please check if RFC connection in SPRO points to the same BPC box?

[kyung-rak_lee]

I aready checked RFC Connection. There're no problem.