on 01-13-2006 3:15 AM
Hi Gurus!
I supposed to Delta Update from r/3 and my Init Delata process was deleted unfortunately,what happens now in the sense what changes occurs in the source system and from where i need to start now........help would be appriciated...
Best Regards
Sunil.
Hello Sunil,
if u have deleted the init request from the cube, u won't have data for the same in the cube!!
First check if the init flag still exist. For this go in the infopckge-> scheduler-> init flags.
if it exists and is not deleted, u can either load data with the same selections (as u did for init)with update type as full update. This will bring in all the data again in the cube which got deleted.
As the init flag still exists, u can schedule delta by scheduling a infopackage with delta update option.
if this is a LO datasource, then u need to ensure the V3 run before the delta upload in BW.
thanks and hope this helps u....
regards,
( dont forget to assign points if this helps..)
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi sunil,
Could you give me more information regarding where you had deleted the initialization from BW or R/3.
And any delta update you had done after initialization.
Regards,
PRK
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
87 | |
10 | |
10 | |
9 | |
7 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.