Skip to Content
author's profile photo Former Member
Former Member

Redwood Wait Events

Hi,

I have configure a job with 3 wait events as the conditio but currently the job is trigger if one of those wait event is raised but i need all the wait event to be raised then only the job should be trigger to run. Any thought on this?

Regards,

Chris

Add a comment
10|10000 characters needed characters exceeded

Related questions

3 Answers

  • author's profile photo Former Member
    Former Member
    Posted on Mar 05, 2015 at 01:07 PM

    Hi Chris,

    You may try building a "Job Chain" and put your wait events into the steps. Think about parallel structures if you want to wait until your 3 conditions apply. Let me send a screenshot, to make you better unterstand:

    Best Regards,

    Serhat


    Unbenannt.png (15.2 kB)
    Add a comment
    10|10000 characters needed characters exceeded

    • Former Member

      Hi Serhat,

      Do you mind to explain in more detail set up your method using the job chain ? As i cannot see there is any tab/collumn to define the event in the steps inside the job chain as i only allow to define job definition inside the job chain. Looking forward for your advise.

      Regards,

      Chris

  • Posted on Mar 06, 2015 at 04:18 AM

    Please provide a screenshot of your setup in waitevent tab.

    Out of the three, set one event to auto-submit - "always", and for the rest of the two - set autosubmit to "Never"

    thanks

    Nanda

    Add a comment
    10|10000 characters needed characters exceeded

  • Posted on Mar 06, 2015 at 07:02 AM

    Hello Chris,

    Is your setup also possible with 1 event definition? In that sense, that all 3 raisers raise the same event instead of using 3 separate event definitions?

    Regards Gerben

    Add a comment
    10|10000 characters needed characters exceeded

Before answering

You should only submit an answer when you are proposing a solution to the poster's problem. If you want the poster to clarify the question or provide more information, please leave a comment instead, requesting additional details. When answering, please include specifics, such as step-by-step instructions, context for the solution, and links to useful resources. Also, please make sure that you answer complies with our Rules of Engagement.
You must be Logged in to submit an answer.

Up to 10 attachments (including images) can be used with a maximum of 1.0 MB each and 10.5 MB total.