on 03-03-2015 1:48 PM
I would like to add an object (cell/table) at the very end of the report, after the all sections and I don't mean page footer.
Is there any way?
Thank you.
Hi Gabriel,
If you put the object outside the bottom of the section, your relative position for Top of Report, will be after the bottom of the last section and will not be duplicated.
Try viewing the report in "Design -> Structure Only" mode to make sure you're placing it outside the section.
Hope this helps.
/Kris
(Green is the section.)
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
Set the relative position "Bottom edge of " table which you used for section.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Ahmed, thank you for detailed reply.
I have tried to do the way you presented and I can do it only if i place the end object at the end of the section and i set the relative position based on bottom edge of other blocks. This way the end object shows repeatedly at the end of each section. I need it only once at the very end of the report.
If i try to place it outside the sections, after them, the only relative position is "Top of the report".
Thank you and regards,
Gabriel
Hi Gabriel,
Probably you can use the relative position and place the cell/table relative to last section. what are you trying to achieve btw ?
Thanks,
Tanveer.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
80 | |
24 | |
12 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.